I have overhauled models such as gas turbines 8000H and 9000HL at Siemens Energy. I have also replaced steam turbine bearings.
I understand I&C drawings, and when installing or replacing new sensors, I can work independently by looking at the FSP.
When installing or removing sensors, I can understand the situation, discuss and improve without unnecessary work.
Since I have often worked on machinery, I can logically understand which sensors should be handled in which machinery process, explain them to the supervisor, and work.
-done a lot of combustor inspections.
-done a lot of HGPI inspections.
-done a lot of major inspections.
-After assessing the situation at each inspection and checking the drawings and FSP, each sensor can be disassembled and assembled.
-Ability to explain I&C to the mechanical team supervisor.
-Burner pullback work possible.
-Ability to perform alignment assistance tasks such as TVC, CVC. Experience utilizing measuring tools such as dial gauges, ID, OD micrometers.
-Experience in disassembling and assembling bearings such as thrust bearings and radial bearings, as well as checking FSP bearings.
-experience in understanding mechanical drawings and rigging bearings to replace MAD11, 12 bearings.
-experience installing sensors such as TC sensors and speed sensors attached to bearings and rotors after bearing replacement. After checking the drawing and FSP, the sensor replacement work can be done independently.
-Understanding of the use of measuring instruments
-Function generator, multimeter, temperature calibrator, power supply, leakage current meter, precision equipment, oscilloscope, oscillator, encoder
-Calibration of instruments connected to the field
-Ability to negotiate with clients
-Switchgear routine maintenance work
-MCC Maintenance Management
-motors related to drainage
-After the switchgear is energized, the function test is performed
-MCC pre-pressurization function test work
-Check rotation direction and wiring before pressurizing the motor
-Installation and diagnosis of equipment for measuring voltage, current, and reverse phase
-Correct the wiring after checking the electrical drawing
-Create a punch list after identifying the problem
I&C work available for steam and gas turbines
I&C drawing understandable
Troubleshooting
Installation and repair
Gas turbine machine work
Steam turbine machine work
Basic English (reading, listening, writing)Basic English (reading, listening, writing)
Customer service
Electrical Industry Engineer
Electrical Industry Engineer
Electrician