JAE-,IN BAE

• Performed EFEM and Transfer Module docking/leveling during new equipment setup.

• Conducted robot teaching for precise wafer pick-and-place position adjustment.

•Executed AWC calibration and adjusted robot parameters and interlock values.

Analyzed equipment failures and performed hardware troubleshooting.

•Inspected and replaced key components including ServoPack, encoder, sensor, valve, and switch.

•Supported equipment stabilization through program patching, software updates, and tuning.

•Responded to LPM and aligner issues and carried out calibration work.

Managed equipment history records, customer spare parts orders, and root cause analysis documentation.

•Prepared service reports, completion reports, and failure analysis reports.

Supported robot delivery, equipment removal, and on-site safety inspections.

• Operated and maintained semiconductor scrubber equipment, including preventive maintenance (PM) and corrective maintenance.

•Analyzed alarm and equipment failure causes, replacing defective parts to restore normal operation.

•Provided technical support for semiconductor process equipment and responded to customer requirements on-site.

•Performed utility inspections and managed critical spare parts condition.

Executed new equipment installation, setup, and modification of existing systems.

• Managed equipment history records, spare parts ordering, and inventory control.

• Diagnosed and corrected electrical issues through circuit inspection and troubleshooting.

•Responded to customer sites and prepared service reports